Zomig is a prescription medicine approved to treat migraine headaches in adults. Only your doctor can determine if Zomig is right for you. Zomig is not for the prevention of migraines or for the treatment of hemiplegic or basilar migraines. Zomig is not for other types of headaches. Click here for complete Approved Use
Point and press for a single 5 mg dose of Zomig
Please read all the instructions before using the Zomig Nasal Spray device for the first time.
The Zomig Nasal Spray device is a blue colored plastic sprayer device with a gray protection cap, labeled to indicate the dose. For adults, the usual dose is a single nasal spray taken into one nostril. If your headache comes back after your first dose, you may take a second dose anytime after 2 hours of taking the first dose. For any attack where the first dose didn’t work, do not take a second dose without talking with your doctor. Do not take more than a total of 10 mg of Zomig (tablets or spray combined) in any 24-hour period. If you take too much medicine, contact your doctor, hospital emergency department, or poison control center right away.
Parts of the Zomig Nasal Spray device
The Zomig Nasal Spray device is a blue plastic sprayer with a gray protective cap, labeled to indicate the dose.
The Zomig Nasal Spray consists of the following parts:
- Zomig Nasal Spray Device. Device not actual size.
- Protective Cap: Covers the tip. Do not remove the protective cap until just before you are ready to use.
- Tip: Located under the protective cap. This is the part you put into your nostril. The medicine comes out of a tiny hole in the top.
- Finger-grips: Hold here when using the sprayer.
- Plunger: This is the part you press when you place the tip into your nostril. This sprayer works only once.
Steps for using Zomig Nasal Spray
Please read all steps before using the Zomig Nasal Spray device for the first time.
- Blow your nose gently before use
- Remove the protective cap (see figure 1 below)
- Hold the nasal sprayer device gently with your fingers and thumb as shown in figure 2 below. There is only one dose in the nasal sprayer. Do not try to prime the nasal sprayer or you will lose the dose. Do not press the plunger until you have put the tip into your nostril or you will lose the dose
- Block one nostril by pressing firmly on the side of your nose. Either nostril can be used. Put the tip of the sprayer device into the other nostril as far as feels comfortable (see figure 3)
- Tilt your head back slightly
Do not press the plunger yet.
- Breathe in gently through your nose and at the same time press the plunger firmly with your thumb. The plunger may feel stiff and you may hear a click
- Remove cap.
- Hold device as show. Block one nostril and tilt head back slightly.
- Insert into opposite nostril and depress plunger.
- Keep your head slightly tilted back and remove the tip from your nose
- Breathe gently through your mouth for 5 to 10 seconds. You may feel liquid in your nose or the back of your throat. This feeling is normal and will soon pass.
Do not spray the contents of the device in your eyes.